DL-CR50311KIT. Set with CIG for measuring the height of washers and springs of CRI1/CRI2 injectors
A set with a CIG for measuring the height of washers and springs, consists of a base, 3 interchangeable adapters, an adapter and a CIG DL-KIP0036.
Adapters CR31584 and DL-CR31585 are used to measure the height of washers Ahe and Rls respectively, for injectors of the CRI1/CRI2 type, DL-CR31583 is used to measure the height of the injector spring of the same type. For a quality measurement, the digital measuring head has an accuracy of 0.001 mm and a stroke of 25 mm.
Spring height measurement sequence:
- Screw the DL-CR31583 adapter into the CIG rod;
- Install and fix the height measurement adapter on the CIG with a gougon;
- Reset the CIG by placing it on a hard, polished surface;
- Install the spring to be measured on the base pin DL-CR31586 from the kit;
- Place the CIG on the base pin with the spring installed;
- To improve accuracy, measure 3 times.
The sequence for measuring the height of washers Ahe/Rls:
- Screw the appropriate adapter CR31584 or DL-CR31585 into the CIG rod;
- Install and fix the height measurement adapter on the CIG with a gougon;
- Place the washer to be measured on a hard, sanded surface;
- Position the adapter relative to the washer so that it covers its entire surface;
- Firmly press the CIG with the installed adapter to the washer, then press “ZERO”;
- When the efforts are weakened and the CIG is pressed away from the washer, the required value will be displayed on the CIG display;
- To improve accuracy, measure 3 times.
*CIG – digital measuring head
